Navcoder Wiring Installed

I need to connect the ULF box to the Navcoder software i have downloaded onto my laptop to set it up for speech instructions. I bought a BM24 bluetooth adapter from ebay – cut off the bluetooth module and wired in the Navcoder USB interface wiring into the short loom.

I removed the tape for clips to make the cable more flexible.

After that it was a straight forward job of unplugging the connector in the boot well and adding in this new adapter. Then it was a matter of positioning the plugs so they were not on the floor of the well …….. prone to water if i suddenly sprung a leak in the boot area.

Your comments:-

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s